 |
|
|
FAQs - HE300GEN100
Q. The keypad will not allow me to change any of the parameters from the default settings.
A. Check the keypad and verify that it doesn't display OPTION ACTIVE at the bottom of the display. If the OPTION is ACTIVE, verify that the jumper is placed between pins 3 and 4 of P1. If the jumper is in place, power-cycle the unit and see if the OPTION is still ACTIVE. If the OPTION is still ACTIVE, call or e-mail Horner Electric's technical support department. Phone number 317-916-4274 ext. 1, or e-mail: techsppt@heapg.com.
Q. How do I change the drive configuration and implement the drive card?
A. Power the drive down and place a jumper between pins 3 and 4 on P1.
- Change the parameters that need to be modified on the drive card.
- Change the size of the Global Data Length and the Directed Data Length accordingly.
- Change the value of P03 of the keypad to 1. This parameter indicates that changes were made.
- Change the value of P02 of the keypad to 1. This parameter turns control of the AF300E$ to the drive card, HE300GEN100.
- Power down the drive and remove the jumper between pins 3 and 4 of P1.
- Verify the the Genius Bus Controller configuration for this node matches the drive card configuration.
Q. The card does not appear to be communicating on the network.
A. Check the "GENA OK" led to see if it is illuminated. The led is located on the actual drive board. If the "GENA OK" led is lit, check the "COMM OK" led. The "COMM OK" led will be lit when the PLC is in run mode and the configuration of the card matches the configuration in the Genius Bus Controller. If the "GENA OK" led is not lit, the drive card will need to be sent in to Horner Electric for repair.
Q. Is it possible to send datagrams to the HE300GEN100?
A. Yes, there is an example in the manual for the drive card.
Q. Is there any programming software available for the option card?
A. Yes, the part number for the software is HE300SFW100. |
|
|
